For use with the Forged Air only. Length can go up to 10 inches(longer lengths upon request). Made of 304 Stainless Steel. These need to be cut on a lathe, not a pipe cutter. One end is faced and the other is chamfered. Chamfered end goes into the push plate(this is the taped end, remove tape from pipe).

Inner diameter of tube is about 1/4" diameter. Each tube is equivalent to four 1/8" incremental lengths. By using the T-tape fastening area O-ring line to make 1/16" or 1/8" indexed increments, it gives more incremental length options at a much cheaper cost(less packing devices and tubes needed).

The push plate accepts two types of rods. Make sure to lightly tighten the set screw on the push plate when using packing tubes. If alternating where you tape at on the skin, tighten the set screw to a friction fit so you can swap rods and still use indirect air.